| Line 4: | Line 4: | ||
{{step|1|Mount your device in a lack or on a table and connect one end of the ethernet cable to the first ethernet port. The ethernet ports of imRAD device support 10/100/1000 BASE-T.}} | {{step|1|Mount your device in a lack or on a table and connect one end of the ethernet cable to the first ethernet port. The ethernet ports of imRAD device support 10/100/1000 BASE-T.}} | ||
| − | {{step|2|Plug the power | + | {{step|2|Plug in the power cord and turn on the power switch that is located in the back of the device. |
| − | + | The power supply supports the Universal AC input(i.e. 90 to 264 VAC). | |
| − | power | ||
}} | }} | ||
Revision as of 15:51, 14 May 2021
This section describes how to configure the imRAD device.
Step 1
Mount your device in a lack or on a table and connect one end of the ethernet cable to the first ethernet port. The ethernet ports of imRAD device support 10/100/1000 BASE-T.
Step 2
Plug in the power cord and turn on the power switch that is located in the back of the device.
The power supply supports the Universal AC input(i.e. 90 to 264 VAC).
Step 3
consle and IP
Step 4
management interface
Step 5
radius
Step 6
dhcp