| Line 20: | Line 20: | ||
Please refer to the [[CLI - System Failover]] section. | Please refer to the [[CLI - System Failover]] section. | ||
| − | |||
=== hostname === | === hostname === | ||
Please refer to the [[CLI - Hostname]] section. | Please refer to the [[CLI - Hostname]] section. | ||
| Line 80: | Line 79: | ||
=== system=== | === system=== | ||
| + | ==== encoding ==== | ||
| + | ==== reset ==== | ||
=== timezone=== | === timezone=== | ||
Revision as of 20:39, 22 April 2021
You can add, change, or delete configuration variables in the Configuration Mode. You can enter the configuration mode using the configure command. To exit from the configuration mode, enter the exit command.
If you enter the help command in the configuration mode, you can see all commands of the mode.
LYSH@MyHostName# configure configure# help
database
Please refer to the CLI - Database section.
dhcpv4, dhcpv6
Please refer to the CLI - Services(daemons) section.
fail2ban
Please refer to the CLI - fail2ban section.
failover
Please refer to the CLI - System Failover section.
hostname
Please refer to the CLI - Hostname section.
ip
Please refer to the CLI - Networking section.
log
logexp
Please refer to the CLI - Services(daemons) section.
loghost
It is the configuration for syslog to log remotely.
LYSH@MyHostName# configure configure# loghost add -h usage: loghost add [-h] <A.B.C.D|WORD> [<[1-65535]>] [<[WORD]>]
To send all logs to the remote server whose address is 192.168.0.100 and port is the default Syslog port(514).
configure# loghost add 192.168.0.100
To send all logs to the remote server whose address is 192.168.0.100 and port is 1000.
configure# loghost add 192.168.0.100 1000
To send logs whose level is greater than or equal to "notice" to the remote server whose address is 192.168.0.100 and port is 1000.
configure# loghost add 192.168.0.100 1000 notice
nameserver
You can add or delete a nameserver of a network interface.
LYSH@MyHostName# configure configure# nameserver add eth0 8.8.8.8 // add a nameserver, 8.8.8.8, into the eth0 interface. configure# nameserver delete eth0 8.8.4.4 // delete a nameserver, 8.8.8.8, from the eth0 interface.
netplan
You can apply the network configuration immediately.
LYSH@MyHostName# configure configure# netplan apply
ntp
You can configure the Network Time Protocol (NTP) server.
LYSH@MyHostName# configure configure# ntp add ntp.ubuntu.com
rtlog
Please refer to the CLI - Services(daemons) section.
system
encoding
reset
timezone
You can configure the timezone of the device.
LYSH@MyHostName# configure configure# tiemzone
ufw
It is the default firewall configuration tool. Please refer to the CLI - ufw section.