(Created page with "Getting started") |
|||
| Line 1: | Line 1: | ||
| − | + | __FORCETOC__ | |
| + | This section describes how to configure the imRAD device. | ||
| + | |||
| + | {{step|1|Mount your device in a lack or on a table and connect one end of the ethernet cable to the first ethernet port. The ethernet ports of imRAD device support 10/100/1000 BASE-T.}} | ||
| + | |||
| + | {{step|2|Plug the power cable and turn on the power switch that is located in the back of the device. | ||
| + | |||
| + | power cable spec. | ||
| + | }} | ||
| + | |||
| + | {{step|3|consle and IP }} | ||
| + | {{step|4|management interface}} | ||
| + | {{step|5|radius} | ||
| + | {{step|6|dhcp}} | ||
Revision as of 15:36, 14 May 2021
This section describes how to configure the imRAD device.
Step 1
Mount your device in a lack or on a table and connect one end of the ethernet cable to the first ethernet port. The ethernet ports of imRAD device support 10/100/1000 BASE-T.
Step 2
Plug the power cable and turn on the power switch that is located in the back of the device.
power cable spec.
Step 3
consle and IP
Step 4
management interface
{{step|5|radius}
Step 6
dhcp