| Line 11: | Line 11: | ||
{{step|3|consle and IP }} | {{step|3|consle and IP }} | ||
{{step|4|management interface}} | {{step|4|management interface}} | ||
| − | {{step|5|radius} | + | {{step|5|radius}} |
{{step|6|dhcp}} | {{step|6|dhcp}} | ||
Revision as of 15:36, 14 May 2021
This section describes how to configure the imRAD device.
Step 1
Mount your device in a lack or on a table and connect one end of the ethernet cable to the first ethernet port. The ethernet ports of imRAD device support 10/100/1000 BASE-T.
Step 2
Plug the power cable and turn on the power switch that is located in the back of the device.
power cable spec.
Step 3
consle and IP
Step 4
management interface
Step 5
radius
Step 6
dhcp