It is the variables that are using in the imRAD services. If the Dynamic is yes, the service applies it in a few seconds. In other words, you don't need to restart the service after configuring variables. If the Dynamic is no, you must restart the service.
entid_from_hostname
- Description: If you set it to "yes", the service reads the enterprise code from the hostname in the DHCP request. It MAY cause a little slow down the performance of the DHCP service. Note that the enterprise codes that can read in the DHCPv4 service are either "Samsung", "Apple", or "Microsoft".
- Target Service: dhcpv4, dhcpv6
- How to configure: CLI - Services(daemons)
- Range: yes | no
- Default Value:: no
- Data Type: boolen
- Dynamic: yes
postdhcp_success
- Description: If you set it to "yes", it saves all results after response but we recommend that only saving the errored results(default) is better because all results can cause a huge number of logs.
- Target Service: dhcpv4, dhcpv6
- How to configure: CLI - Services(daemons)
- Range: yes | no
- Default Value:: no
- Data Type: boolen
- Dynamic: yes
check_reserv_ip_at_renew
- Description: If you set it to "yes", If the DHCP service receives a RENEW and an IP address exists that is not same to the request IP address in the RENEW message, the DHCP service responds with NAK(DHCPv4) or replies with "NoBinding" error to assign the reserved IP address to have a client is assigned the reserved IP address. If an administrator reserves a different IP address for the same host after the host was assigned an IP address, this case may occur.
- Target Service: dhcpv4, dhcpv6
- How to configure: CLI - Services(daemons)
- Range: yes | no
- Default Value:: no
- Data Type: boolen
- Dynamic: yes
dhcpv4_expire_check_intv
- Description: It is the interval in seconds to check the lease expiration.
- Target Service: dhcpv4
- How to configure: CLI - Services(daemons)
- Range: 30 ~ 2,147,483,648
- Default Value:: 600
- Data Type: 초(sec)
- Dynamic: yes
dhcpv6_expire_check_intv
- Description: It is the interval in seconds to check the lease expiration.
- Target Service: dhcpv6
- How to configure: CLI - Services(daemons)
- Range: 30 ~ 2,147,483,648
- Default Value:: 600
- Data Type: 초(sec)
- Dynamic: yes
dhcpv4_decline_age
- Description: It is the time in seconds to change the status from "decl" to "avail" of the declined IP addresses.
- Target Service: dhcpv4
- How to configure: CLI - Services(daemons)
- Range: 300 ~ 2,147,483,648
- Default Value:: 1200
- Data Type: 초(sec)
- Dynamic: yes
dhcpv6_decline_age
- Description: It is the time in seconds to change the status from "decl" to "avail" of the declined IP addresses.
- Target Service: dhcpv6
- How to configure: CLI - Services(daemons)
- Range: 300 ~ 2,147,483,648
- Default Value:: 1200
- Data Type: 초(sec)
- Dynamic: yes