You can add, change, or delete configuration variables in the Configuration Mode. You can enter the configuration mode using the configure command. To exit from the configuration mode, enter the exit command.
If you enter the help command in the configuration mode, you can see all commands in the mode.
LYSH@MyHostName# configure configure# help
database
Please refer to the CLI - Database section.
dhcpv4, dhcpv6
Please refer to the CLI - Services(daemons) section.
fail2ban
Fail2Ban is an intrusion prevention software framework that protects devices from brute-force attacks. Fail2Ban is typically set up to unban a blocked host within a certain period, so as to not "lock out" any genuine connections that may have been temporarily misconfigured. However, an unban time of several minutes is usually enough to stop a network connection being flooded by malicious connections, as well as reducing the likelihood of a successful dictionary attack.[1]
LYSH@MyHostName# configure
configure# fail2ban -h
positional arguments:
bantime the number of seconds that a host is banned
maxretry the number of failures before a host get banned
disable disable fail2ban service
enable enable fail2ban service
If you want to verify the current configuration, enter the show system fail2ban after exit from the configuration mode.
failover
Please refer to the CLI - System Failover section.
history
hostname
Please refer to the CLI - Hostname section.
ip
Please refer to the CLI - Networking section.
log
logexp
Please refer to the CLI - Services(daemons) section.
loghost
It is the configuration for syslog to log remotely.
LYSH@MyHostName# configure configure# loghost add -h usage: loghost add [-h] <A.B.C.D|WORD> [<[1-65535]>] [<[WORD]>]
To send all logs to the remote server whose address is 192.168.0.100 and port is the default Syslog port(514).
configure# loghost add 192.168.0.100
To send all logs to the remote server whose address is 192.168.0.100 and port is 1000.
configure# loghost add 192.168.0.100 1000
To send logs whose level is greater than or equal to "notice" to the remote server whose address is 192.168.0.100 and port is 1000.
configure# loghost add 192.168.0.100 1000 notice
nameserver
You can add or delete a nameserver of a network interface.
LYSH@MyHostName# configure configure# nameserver add eth0 8.8.8.8 // add a nameserver, 8.8.8.8, into the eth0 interface. configure# nameserver delete eth0 8.8.4.4 // delete a nameserver, 8.8.8.8, from the eth0 interface.
netplan
You can apply the network configuration immediately.
LYSH@MyHostName# configure configure# netplan apply
ntp
You can configure the Network Time Protocol (NTP) server.
LYSH@MyHostName# configure configure# ntp add ntp.ubuntu.com
rtlog
Please refer to the CLI - Services(daemons) section.
system
timezone
You can configure the timezone of the device.
LYSH@MyHostName# configure configure# tiemzone