Getting started

This section describes a brief tutorial on how to install, access, and configure the imRAD device.
However, you have to read the imRAD wiki for more details.

Step 1

Mount your device in a lack or on a table and connect one end of the ethernet cable to the first ethernet port. The ethernet ports of imRAD device support 10/100/1000 BASE-T.

Step 2

Plug in the power cord and turn on the power switch that is located in the back of the device. The power supply supports the Universal AC input(i.e. 90 to 264 VAC).

Step 3

Connect to the device using a console, The console port of the imRAD device is located in front of the device, the baud rate(speed) is 115,200 and the serial port type is an RJ-45 connector. The default or initial Username and Password for login are ladmin and 1111 respectively. And then, change the default password to another to access the imRAD CLI(i.e. "LYSH).

After accessing the CLI, you have to set an IP address on the device. Please refer to the CLI - Networking section to know how to configure an IP address.

You can also change the hostname of a device by entering hostname set {newhostname} in the configuration mode

For more commands, Please refer to the Command Line Interface (CLI, LYSH) section.

Step 4

Open the imRAD Management Interface on your browser and log in. The URL is https://<imrad.configured.ip.address>.

Step 5

Configure the imRAD RADIUS and DHCP service on the management interface.

• Configuring the RADIUS
• Configuring the DHCP

After configuring the RADIUS, you may leave out configuring the DHCP if you have already DHCP servers and want to use the existing servers.